FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\Ethernet.fm
set interface active
Use the set interface active EXEC mode command to reactivate an interface
that was shut down.
Syntax
{ interface-id }
set interface active
Parameters
interface-id—Specifies an interface ID. The interface ID can be one of the
following types: Ethernet port or Port-channel.
Command Mode
EXEC mode
User Guidelines
This command is used to activate interfaces that were configured to be active,
but were shut down by the system.
Example
The following example reactivates gigabitethernet port 1/0/1.
Console#
gigabitethernet 1/0/1
set interface active
show interfaces configuration
Use the show interfaces configuration EXEC mode command to display the
configuration for all configured interfaces or for a specific interface.
Syntax
[interface-id ]
show interfaces configuration
Parameters
interface-id—Specifies an interface ID. The interface ID can be one of the
following types: Ethernet port or Port-channel.
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 5 / 1 5 / 1 2 - F O R P R O O F O N LY
339
Ethernet Configuration Commands