Configuring Smart Call Home; Configuring Contact Information - Cisco Nexus 7000 Series Configuration Manual

Configuring Smart Call Home

Parameters
HTTP proxy server use
Configuring Smart Call Home
Be aware that the Cisco NX-OS commands may differ from the Cisco IOS commands.
Note
We recommend that you complete the Smart Call Home configuration procedures in the following sequence:
1 Configuring Contact Information, on page 116
2 Creating a Destination Profile, on page 118
Associating an Alert Group with a Destination Profile, on page 121
3
4 (Optional)
5 Enabling or Disabling Smart Call Home, on page 129
6 (Optional)

Configuring Contact Information

You must configure the email, phone, and street address information for Smart Call Home. You can optionally
configure the contract ID, customer ID, site ID, and switch priority information.
Procedure
Step 1
Step 2
Step 3
Cisco Nexus 7000 Series NX-OS System Management Configuration Guide
116
Adding Show Commands to an Alert Group, on page 122
Testing the Smart Call Home Configuration, on page 130
Command or Action
configure terminal
Example:
switch# configure terminal
switch(config)#
snmp-server contact sys-contact
Example:
switch(config)# snmp-server
contact personname@companyname.com
callhome
Example:
switch(config)# callhome
switch(config-callhome)#
Default
Disabled and no proxy server configured
Purpose
Enters global configuration mode.
Configures the SNMP sysContact.
Enters Smart Call Home configuration mode.
Configuring Smart Call Home