Example Configuration - Cisco 2950G 24 - Catalyst Switch Software Configuration Manual

Assigning Switch Information
Note The switch broadcasts TFTP server requests if the TFTP server is not obtained from the DHCP replies,
if all attempts to read the configuration file through unicast transmissions fail, or if the TFTP server
name cannot be resolved to an IP address.

Example Configuration

Figure 4-3
Figure 4-3
Cisco router
Table 4-2
Table 4-2 DHCP Server Configuration
Switch-1
Binding key 00e0.9f1e.2001
(hardware address)
IP address 10.0.0.21
Subnet mask 255.255.255.0
Router address 10.0.0.10
DNS server address 10.0.0.2
TFTP server name maritsu or 10.0.0.3
Boot filename switch1-confg
(configuration file)
(optional)
Host name (optional) switch1
Catalyst 2950 Desktop Switch Software Configuration Guide
4-8
shows a sample network for retrieving IP information by using DHCP-based autoconfiguration.
DHCP-Based Autoconfiguration Network Example
Switch 1 Switch 2
00e0.9f1e.2001 00e0.9f1e.2002
10.0.0.10
10.0.0.1
DHCP server
shows the configuration of the reserved leases on the DHCP server.
Switch-2
00e0.9f1e.2002
10.0.0.22
255.255.255.0
10.0.0.10
10.0.0.2
maritsu or 10.0.0.3
switch2-confg
switch2
Chapter 4 Assigning the Switch IP Address and Default Gateway
Switch 3
00e0.9f1e.2003 00e0.9f1e.2004
10.0.0.2 10.0.0.3
DNS server TFTP server
(maritsu)
Switch-3
00e0.9f1e.2003
10.0.0.23
255.255.255.0
10.0.0.10
10.0.0.2
maritsu or 10.0.0.3
switch3-confg
switch3
Switch 4
Switch-4
00e0.9f1e.2004
10.0.0.24
255.255.255.0
10.0.0.10
10.0.0.2
maritsu or 10.0.0.3
switch4-confg
switch4
78-14982-01