Cisco 2950G 24 - Catalyst Switch Software Configuration Manual page 56

IOS Command Modes
Table 2-1
and how to exit the mode. The examples in the table use the host name Switch.
Table 2-1 Command Mode Summary
Mode Access Method
User EXEC Begin a session with
your switch.
Privileged EXEC While in user EXEC
mode, enter the
enable command.
Global configuration While in privileged
EXEC mode, enter
the configure
command.
Config-vlan While in global
configuration mode,
enter the
vlan vlan-id
command.
Config-lre-sequence While in global
configuration mode
enter
<sequence_name>
Config-lre-controller While in global
configuration mode
enter
controller
<controller_name>
Catalyst 2950 Desktop Switch Software Configuration Guide
2-2
describes the main command modes, how to access each one, the prompt you see in that mode,
Prompt
Switch>
Switch#
Switch(config)#
Switch(config-vlan)#
config-seq#
lre sequence
config-controller#
lre
Chapter 2 Using the Command-Line Interface
Exit Method About This Mode
Enter logout or quit. Use this mode to
•
•
•
Enter disable to exit. Use this mode to verify
commands that you have
entered. Use a password to
protect access to this mode.
To exit to privileged Use this mode to configure
EXEC mode, enter parameters that apply to the
exit or end, or press entire switch.
Ctrl-Z.
To exit to global Use this mode to configure
configuration mode, VLAN parameters. When
enter the exit VTP mode is transparent,
command. you can create
extended-range VLANs
To return to
(VLAN IDs greater than
privileged EXEC
1005) and save
mode, press Ctrl-Z or
configurations in the switch
enter end.
startup configuration file.
To exit to global Use this mode to create new
configuration mode, sequences or to add or delete
enter the exit profiles in a user-defined
command. sequence.
To return to
privileged EXEC
mode, press Ctrl-Z or
enter end.
To exit to global Use this mode for all
configuration mode, upgrade related commands
enter the exit (for further information on
command. upgrading, see the
"Upgrading LRE Switch
To return to
Firmware" section on
privileged EXEC
page
mode, press Ctrl-Z or
enter end.
Change terminal
settings.
Perform basic tests.
Display system
information.
10-15).
78-14982-01