Configuring Switch Interfaces - Cisco 2950G 24 - Catalyst Switch Software Configuration Manual

Chapter 9 Configuring the Switch Interfaces
This example shows how to define an interface-range macro named enet_list to select Fast Ethernet
ports 1 to 4 and to verify the macro configuration:
Switch# configure terminal
Switch(config)# define interface-range enet_list fastethernet0/1 - 4
Switch(config)# end
Switch# show running-config | include define
define interface-range enet_list FastEthernet0/1 - 4
This example shows how to create a multiple-interface macro named macro1:
Switch# configure terminal
Switch(config)# define interface-range macro1 gigabitethernet0/1 - 2, fastethernet0/5 - 7
Switch(config)# end
Switch#
This example shows how to enter interface range configuration mode for the interface-range macro
enet_list:
Switch# configure terminal
Switch(config)# interface range macro enet_list
Switch(config-if-range)#
This example shows how to delete the interface-range macro enet_list and to verify that it has been
deleted.
Switch# configure terminal
Switch(config)# no define interface-range enet_list
Switch# show run | include define

Configuring Switch Interfaces

The switch supports these interface types:
•
•
•
These sections describe the default interface configuration and the optional features that you can
configure on most physical interfaces:
•
•
•
•
•
•
78-14982-01
Physical ports-Switch ports, including access, trunk, and LRE ports
VLANs-Switch virtual interfaces (SVIs)
Port-channels-EtherChannel of interfaces
Default Ethernet Interface Configuration, page 9-10
SFP Configuration, page 9-10
Configuring Interface Speed and Duplex Mode, page 9-11
Configuring Media Types for Gigabit Interfaces, page 9-14
Configuring IEEE 802.3X Flow Control on Gigabit Ethernet Ports, page 9-14
Adding a Description for an Interface, page 9-16
Catalyst 2950 Desktop Switch Software Configuration Guide
Configuring Switch Interfaces
9-9