Verifying A Switch Cluster - Cisco 2950G 24 - Catalyst Switch Software Configuration Manual

Creating a Switch Cluster

Verifying a Switch Cluster

When you finish adding cluster members, follow these steps to verify the cluster:
Enter the command switch IP address in the browser Location field (Netscape Communicator) or
Step 1
Address field (Microsoft Internet Explorer) to access all switches in the cluster.
Enter the command-switch password.
Step 2
Select View > Topology to display the cluster topology and to view link information (see
Step 3
page
links, and colors, see the
Select Reports > Inventory to display an inventory of the switches in the cluster (see
Step 4
The summary includes information such as switch model numbers, serial numbers, software versions,
IP information, and location.
You can also display port and switch statistics from Reports > Port Statistics and Port > Port Settings
> Runtime Status.
Instead of using CMS to verify the cluster, you can use the show cluster members user EXEC command
from the command switch or use the show cluster user EXEC command from the command switch or
from a member switch.
Figure 6-14 Inventory Window
If you lose connectivity with a member switch or if a command switch fails, see the
Procedures" section on page
For more information about creating and managing clusters, refer to the online help. For information
about the cluster commands, refer to the switch command reference.
Catalyst 2950 Desktop Switch Software Configuration Guide
6-24
3-11). For complete information about the Topology view, including descriptions of the icons,
"Topology View" section on page
28-6.
3-10.
12.1(4)EA1
10.10.10.6
10.10.10.7 12.0(5)WC2
10.1.1.2, 10.10.10.1, 10. 12.1(4)EA1
10.10.10.2
10.10.10.3 12.1(6)EA2
10.10.10.9 13.0(5)XU
Chapter 6 Clustering Switches
Figure 3-8 on
Figure 6-14).
"Using Recovery
78-14982-01