Cisco 2950G 24 - Catalyst Switch Software Configuration Manual page 535
Desktop switch
Hide thumbs
Also See for 2950G 24 - Catalyst Switch:
- Migration manual (25 pages) ,
- Datasheet (19 pages) ,
- Product support bulletin (5 pages)
Table of Contents
Advertisement
Chapter 26
Configuring QoS
Command
Step 3
end
Step 4
show access-lists
Step 5
copy running-config startup-config
For more information about creating IP standard ACLs, see the
Physical Interfaces" section on page
To delete an ACL, use the no access-list access-list-number global configuration command.
This example shows how to allow access for only those hosts on the two specified networks. The
wildcard bits apply to the host portions of the network addresses. Any host with a source address that
does not match the ACL statements is rejected.
Switch(config)# access-list 1 permit 192.5.255.0 0.0.0.255
Switch(config)# access-list 1 permit 36.0.0.0 0.0.0.255
78-14982-01
Purpose
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
25-6.
Catalyst 2950 Desktop Switch Software Configuration Guide
Configuring QoS
"Guidelines for Applying ACLs to
26-17
Advertisement
Table of Contents
Troubleshooting
