Configuring A Range Of Interfaces - Cisco 2950G 24 - Catalyst Switch Software Configuration Manual

Using the Interface Command
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
<output truncated>

Configuring a Range of Interfaces

You can use the interface range global configuration command to configure multiple interfaces with the
same configuration parameters. When you enter the interface-range configuration mode, all command
parameters that you enter are attributed to all interfaces within that range until you exit this mode.
Beginning in privileged EXEC mode, follow these steps to configure a range of interfaces with the
same parameters:
Command
Step 1
configure terminal
Step 2
interface range {port-range | macro
macro_name}
Step 3
Step 4
end
Step 5 show interfaces [interface-id]
Step 6
copy running-config startup-config
When using the interface range global configuration command, note these guidelines:
•
Catalyst 2950 Desktop Switch Software Configuration Guide
9-6
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 input packets with dribble condition detected
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 2 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
Valid entries for port-range:
vlan vlan-ID - vlan-ID, where VLAN ID is from 1 to 1005 with the SI installed or 1 to 4094
–
with the EI installed
– fastethernet slot/{first port} - {last port}, where slot is 0
Purpose
Enter global configuration mode.
Enter interface-range configuration mode by entering the range of
interfaces (VLANs or physical ports) to be configured.
• You can use the interface range command to configure up to five
port ranges or a previously defined macro.
• The macro variable is explained in the
Interface-Range Macros" section on page
• Each comma-separated port-range must consist of the same port
type. You do not need to enter spaces before or after the comma.
• When you define a range, the space between the first port and the
hyphen is required.
You can now use the normal configuration commands to apply the
configuration parameters to all interfaces in the range.
Return to privileged EXEC mode.
Verify the configuration of the interfaces in the range.
(Optional) Save your entries in the configuration file.
Chapter 9 Configuring the Switch Interfaces
"Configuring and Using
9-8.
78-14982-01