Configuration Examples For Fibre Channel Interfaces; Configuration Example For Fec Module Interfaces - Cisco MDS 9000 Series Configuration Manual

Configuration Examples for Fibre Channel Interfaces

Configuration Examples for Fibre Channel Interfaces

Configuration Example for FEC Module Interfaces

These steps describe how to configure FEC module interfaces:
Step 1
Select the interfaces fc 4/1 through fc 4/2.
Example:
switch# configure terminal
switch(config)# interface fc 4/1 - 2
Step 2
Configure the FEC on the interfaces.
Example:
switch(config-if)# switchport speed 16000
switch(config-if)# switchport fec
Step 3
Enable the interfaces and return to configuration mode.
Example:
switch(config-if)# no shutdown
switch(config-if)# exit
Step 4
Select the interfaces fc 4/3 through fc 4/4.
Example:
switch# configure terminal
switch(config)# interface fc 4/3 - 4
Step 5
Configure the port speed, rate mode, and port mode on the interfaces.
Example:
switch(config-if)# switchport speed 16000
switch(config-if)# switchport fec
Cisco MDS 9000 Series Interfaces Configuration Guide, Release 8.x
106
Configuring Fibre Channel Interfaces