Cisco 2950G 24 - Catalyst Switch Software Configuration Manual page 84

Menus and Toolbar
Table 3-11 Menu Bar (continued)
Menu-Bar Options
2
STP
2
IGMP Snooping
1
802.1X
2
ACL
1
(guide mode available )
1
Security Wizard
2
QoS
(guide mode available on some
1
options )
1
AVVID Wizards
LRE Profiles
LRE Rate Selection
Port
2
Port Settings
Port Search
1
Port Security
2
EtherChannels
2
SPAN
2
Protected Port
2
Flooding Control
VLAN
2
VLAN
1
(guide mode available )
2
Management VLAN
2
VMPS
Catalyst 2950 Desktop Switch Software Configuration Guide
3-18
Task
Display and configure STP parameters for a switch.
Enable and disable Internet Group Management Protocol (IGMP) snooping and IGMP
Immediate-Leave processing on the switch. Join or leave multicast groups, and configure
multicast routers.
Configure 802.1X authentication of devices as they are attached to LAN ports in a
point-to-point infrastructure.
Create and maintain access control lists (ACLs), and attach ACLs to specific ports.
Filter certain traffic, such as HTTP traffic, to certain networks or devices. Restrict access
to servers, networks, or application data from certain networks or devices.
Display submenu options to enable and disable quality of service (QoS) and to configure
or modify these parameters:
2
• Trust settings
2
• Queues
2
• Maps
2
Classes (guide mode available
•
2
Policies (guide mode available
•
1
Voice Wizard —Configure a port to send or receive voice traffic.
•
1
• Video Wizard —Optimize multiple video servers for sending video traffic.
1
• Data Wizard —Provide a higher priority to specific applications.
Set profiles for a switch.
Set rate selection parameters for automatically assigning profiles, setting signal-to-noise
(SNR) margins, locking profiles, and qualifying links.
Display and configure port parameters on a switch.
Search for a port through its description.
Enable port security on a port.
Group ports into logical units for high-speed links between switches.
Enable Switch Port Analyzer (SPAN) port monitoring.
Configure a port to prevent it from receiving bridged traffic from another port on the
same switch.
Block the normal flooding of unicast and multicast packets, and enable the switch to
block packet storms.
Display VLAN membership, assign ports to VLANs, and configure 802.1Q trunks.
Display and configure the VLAN Trunking Protocol (VTP) for interswitch VLAN
membership.
Change the management VLAN on the switch.
Configure the VLAN Membership Policy Server (VMPS).
Chapter 3
1
)
1
)
Getting Started with CMS
78-14982-01