2-Port Oc48-Pos/Rpr Spa Interface Specifications; 2-Port Oc48-Pos/Rpr Spa Cables, Optical Transceiver Modules, And Connectors; Figure 2-28 Duplex Patch Cable With Lc-Type Connectors - Cisco 12000 - Series Chassis Modular Expansion Base Hardware Installation Manual
Router sip and spa
Hide thumbs
Also See for 12000 - Series Chassis Modular Expansion Base:
- User manual (602 pages) ,
- Installation and configuration manual (62 pages) ,
- Hardware installation manual (62 pages)
Table of Contents
Advertisement
Chapter 2
Overview: Cisco 12000 Series Router Shared Port Adapters
Table 2-30 2-Port OC48-POS/RPR SPA LEDs (continued)
LED Label
ACT
STATUS
2-Port OC48-POS/RPR SPA Interface Specifications
The physical layer interface for the 2-Port OC48-POS/RPR SPA is Optical Carrier-48 (OC-48), and the
2-Port OC48-POS/RPR SPA is designed to comply with POS specifications. The
2-Port OC48-POS/RPR SPA provides two 2.488-Gbps network interfaces for all supported platforms.
2-Port OC48-POS/RPR SPA Cables, Optical Transceiver Modules, and
Connectors
Use single-mode (for intermediate-configurations) optical fiber cable to connect your router to a network
or to connect two OC-48-equipped routers back-to-back.
The 2-Port OC48-POS/RPR SPA supports the following types of optical transceiver modules:
•
•
•
Each port on the 2-Port OC48-POS/RPR SPA has one duplex LC-type receptacle. For single-mode
optical fiber connections, you can use either a duplex LC-type cable (see
LC-type cables, one for transmit (TX) and one for receive (RX).
Figure 2-28 Duplex Patch Cable with LC-Type Connectors
RX
Release 12.0(32)SY1, OL-8831-01, Rev. G6, July 19, 2007
Color
Amber
Off
Green
Amber
Off
Green
Amber
Single-mode short-reach (SR) SFP module—SFP-OC48-SR
Single-mode intermediate-reach (IR) SFP module —SFP-OC48-IR1
Single-mode long-reach (LR) SFP module — SFP-OC48-LR2
TX
State
Meaning
Blinking Port is locally steering
Off
Port is not enabled by software.
On
Port is enabled by software, loopback is off.
On
Port is enabled by software, loopback is on.
Off
SPA power is off.
On
SPA is ready and operational.
On
SPA power is on and good, and SPA is being
configured.
/ /
/ /
/ /
Cisco 12000 Series Router SIP and SPA Hardware Installation Guide
2-Port OC-48 POS RPR SPA Overview
Figure
2-28) or two simplex
2-43
Advertisement
Table of Contents
Troubleshooting
