Using Show Commands To Display Spa Information; Table 5-2 Show Commands To Display Spa Information - Cisco 12000 - Series Chassis Modular Expansion Base Hardware Installation Manual

Checking the Installation
For more information about FPD upgrades, refer to the "Upgrading Field-Programmable
Devices" chapter of the Cisco 7600 Series Router SIP, SSC, and SPA Software Configuration Guide.
Use the show version command to obtain a few details on the installed SIPs and interfaces available.
Step 5

Using show Commands to Display SPA Information

Table 5-1
Table 5-1
Command
show running-config
show hw-module subslot all oir
show diag
show hw-module subslot all fpd FPD version information of SPAs in the system.
show version
Table 5-2 show Commands to Display SPA Information
Command
show controllers type
slot/subslot/port
show interfaces type
slot/subslot/port
show diag slot
show version
A Fast Ethernet interface is used in the following examples for illustrative purposes.
Note
The following sample display shows the events logged by the system as an SIP with a Fast Ethernet SPA
was removed from module slot 3; the system then reinitializes the remaining interface processors and
marks as down the Fast Ethernet interface on the SIP that was removed from slot 3.
Router#
18:04:29: %OIR-6-REMCARD: Card removed from slot 3, interfaces disabled
18:04:30: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet3/0, changed state
to down
Cisco 12000 Series Router SIP and SPA Hardware Installation Guide
5-6
describes the show commands you can use to display SPA information.
show Commands to Display SPA Information
Type of Information Provided
Network link status, register contents, and
controller chip errors.
Line status and data link protocol status for a
particular SPA port. Statistics about data traffic
sent and received by the port.
SPA type in that slot, number of ports, hardware
revision, part number, and EEPROM contents.
Cisco IOS software version, names and sources of
configuration files, and boot images.
Chapter 5
Type of Information Provided
The router's running configuration and interfaces available in the
system.
The operational status of all SPAs in the system.
SPA type in that slot, number of ports, hardware revision, part
number, and EEPROM contents.
Cisco IOS software version, names and sources of configuration
files, and boot images.
Release 12.0(32)SY1, OL-8831-01, Rev. G6, July 19, 2007
Installing and Removing a Shared Port Adapter
Example
show controllers pos 2/3/0
show interfaces pos 2/2/0
show diag 4
show version