10-Port Gigabit Ethernet SPA Overview
10-Port Gigabit Ethernet SPA LEDs
The 10-Port Gigabit Ethernet SPA has two types of LEDs: an A/L LED for the port and a STATUS LED,
as shown in
Figure 2-14 10-Port Gigabit Ethernet SPA Faceplate
1
Table 2-21
Table 2-21 10-Port Gigabit Ethernet SPA LEDs
LED Label
A/L
STATUS
10-Port Gigabit Ethernet SPA Cables and Connectors
The 10-Port Gigabit Ethernet SPA has ten electrical connectors which support SFPs modules. Each port
can send and receive traffic using cabling appropriate for the SFP module inserted.
SFP Module Connections
The small form-factor pluggable (SFP) module is an input/output (I/O) device that plugs into the Gigabit
Ethernet optical slots on the 10-Port Gigabit Ethernet SPA, linking the port with a 1000BASE-X
fiber-optic network.
Cisco 12000 Series Router SIP and SPA Hardware Installation Guide
2-24
Figure
2-14.
1
A/L (Active/Link) LED
describes the 10-Port Gigabit Ethernet SPA LEDs.
Color
Off
Green
Amber
Off
Green
Amber
Chapter 2
Overview: Cisco 12000 Series Router Shared Port Adapters
2
STATUS LED
State
Meaning
Off
Port is not enabled.
On
Port is enabled and the link is up.
On
Port is enabled and the link is down.
Off
SPA power is off.
On
SPA is ready and operational.
On
SPA power is on and good, and SPA is being configured.
Release 12.0(32)SY1, OL-8831-01, Rev. G6, July 19, 2007
2