Spa Blank Filler Plates; Table 5-3 Show Commands To Display Spa Information - Cisco 12000 - Series Chassis Modular Expansion Base Hardware Installation Manual

Chapter 5 Installing and Removing a Shared Port Adapter
Router# ping 10.1.1.60 <Return>
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echoes to 10.1.1.60, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/15/64 ms
Router#
If the connection fails, verify that you have the correct IP address for the server and that the server is
active (powered on), and repeat the ping command.
Table 5-3 show Commands to Display SPA Information
Command
show controllers type
slot/subslot/port
show interfaces type
slot/subslot/port
show diag slot
show version

SPA Blank Filler Plates

.
SPA blank filler plates are available to fill an unused SPA subslot. A special SPA blank filler plate is
preinstalled for the 7600-SIP-600 bay 1.
When a SPA subslot is not in use, a SPA blank filler plate must be installed in the empty subslot to allow
the router or switch to conform to electromagnetic interference (EMI) emissions requirements and to
allow proper airflow across the SPAs. If you plan to install a new SPA in a subslot that is not in use, you
must first remove the SPA blank filler plate.
Release 12.0(32)SY1, OL-8831-01, Rev. G6, July 19, 2007
Type of Information Provided
Network link status, register contents, and
controller chip errors.
Line status and data link protocol status for a
particular SPA port. Statistics about data traffic
sent and received by the port.
SPA type in that slot, number of ports, hardware
revision, part number, and EEPROM contents.
Cisco IOS software version, names and sources of
configuration files, and boot images.
Cisco 12000 Series Router SIP and SPA Hardware Installation Guide
.SPA Blank Filler Plates
Example
show controllers pos 2/3/0
show interfaces pos 2/2/0
show diag 4
show version
5-9