Spa Subslot Numbering On The Cisco 12000 Sip-601; Spa Interface Addresses On The Cisco 12000 Sip-601; Figure 1-7 Subslot Locations For The 1-Port 10-Gigabit Ethernet Spa; Figure 1-19 Subslot Locations For The 1-Port 10-Gigabit Ethernet Spa - Cisco 12000 - Series Chassis Modular Expansion Base Hardware Installation Manual

Cisco 12000 SIP-601 Overview
Table 1-17 Cisco 12000 SIP-601 Physical Specifications
Description
Relative humidity
Storage temperature

SPA Subslot Numbering on the Cisco 12000 SIP-601

The Cisco 12000 SIP-601 accepts 4 single-height SPAs (the aggregate throughput should not exceed 2
full-rate SPAs); 2 double-height SPAs; 1 dual-width, double-height SPA, or a combination of
single-height and double-height SPAs.
Figure 1-19
right SPA slot is subslot 1. If one dual-width SPA is installed, it is recognized as being in subslot 0.

Figure 1-19 Subslot Locations for the 1-Port 10-Gigabit Ethernet SPA

Table 1-18 Subslot Locations for the 1-Port 10-Gigabit Ethernet SPA
Call Out Number
1
2

SPA Interface Addresses on the Cisco 12000 SIP-601

A Cisco 12000 Series Router identifies a SPA interface address by its SIP slot number, SPA subslot, and
port number on the SPA, in the format slot/subslot/port. Subslots and ports are numbered starting from
0, so each Cisco 12000 SIP-601 has two subslots 0 (left) and 1 (right). For example, the interface address
of a 1-port SPA located in the second SIP subslot, where the SIP is inserted into router line card slot 3
is 3/1/0.
and the 10-Port Gigabit Ethernet SPA.
Cisco 12000 Series Router SIP and SPA Hardware Installation Guide
1-20
Specifications
10 to 90 percent, noncondensing
–4 to 149°F (–20 to 65°C)
shows a Cisco 12000 SIP-601 with 2 SPAs installed. The left SPA slot is subslot 0 and the
1
2
Description
Subslot 0
Subslot 1
Figure 1-20 shows the slot, subslot, and port locations for the 1-Port 10-Gigabit Ethernet SPA
Chapter 1 Overview: Cisco 12000 Series Router SPA Interface Processors
Release 12.0(32)SY1, OL-8831-01, Rev. G6, July 19, 2007