2-Port OC-48 POS RPR SPA Overview
2-Port OC-48 POS RPR SPA Overview
The following sections describe the 2-Port OC48-POS/RPR SPA:
•
•
•
2-Port OC48-POS/RPR SPA LEDs
The 2-Port OC48-POS/RPR SPA has five LEDs, as shown in
Figure 2-27 2-Port OC48-POS/RPR SPA Faceplate
1
2
3
The 2-Port OC48-POS/RPR SPA LEDs are described in
Table 2-30 2-Port OC48-POS/RPR SPA LEDs
LED Label
PTH
CAR
PRT
Cisco 12000 Series Router SIP and SPA Hardware Installation Guide
2-42
2-Port OC48-POS/RPR SPA LEDs, page 2-42
2-Port OC48-POS/RPR SPA Interface Specifications, page 2-43
2-Port OC48-POS/RPR SPA Cables, Optical Transceiver Modules, and Connectors, page 2-43
1 2
3 4
PTH (Pass-Through) LED
PRT (Protect) LED
CAR (Carrier/Alarm) LED
Color
Off
Amber
Off
Green
Amber
Amber
Off
Green
Green
Amber
Chapter 2
Overview: Cisco 12000 Series Router Shared Port Adapters
4
ACT (Active Loopback) LED
5
STATUS LED
Table
State
Meaning
Off
Port is not in pass-through mode.
On
Port is in pass-through mode.
Off
Port is not enabled by software.
On
Port is enabled by software, and there is a valid
SONET signal without any alarms.
On
Port is enabled by software, and there is at least
one alarm.
Blinking Port is enabled by software, and there is a side
mismatch.
Off
Port is not in wrap mode or steer.
On
A node on the ring is wrapped.
Blinking A node on the ring is steering pass-through
On
Port is locally wrapped
Release 12.0(32)SY1, OL-8831-01, Rev. G6, July 19, 2007
Figure
2-27.
SPA-2XOC48-POS/RPR
2-30.
5