Chapter 4 Installing And Removing A Spa Interface Processor; Handling Sips - Cisco 12000 - Series Chassis Modular Expansion Base Hardware Installation Manual

Installing and Removing a SPA Interface
Processor
Release 12.0(32)SY1, OL-8831-01, Rev. G6, July 19, 2007
This chapter describes how to install or remove SIPs on the Cisco 12000 series router. This chapter
contains the following sections:
•
•
•
•
•

Handling SIPs

Each SIP circuit board is mounted to a metal carrier and is sensitive to electrostatic discharge (ESD)
damage. Before you begin installation, read
Port Adapter"
Always handle the SIP by the carrier edges and handle; never touch the SIP components or connector
Caution
pins. (See
When a slot is not in use, a blank filler plate must fill the empty slot to allow the router to conform to
electromagnetic interference (EMI) emissions requirements and to allow proper airflow across the
installed modules. If you plan to install a SIP in a slot that is not in use, you must first remove the blank
filler plate.
Release 12.0(32)SY1, OL-8831-01, Rev. G6, July 19, 2007
Handling SIPs, page 4-1
Removing and Installing a SIP, page 4-2
Guidelines for SIP Removal and Installation, page 4-2
Removing a SIP, page 4-3
Installing a SIP, page 4-5
for a list of parts and tools required for installation.
Figure 4-1.)
C H A P T E R
"Preparing to Install a SPA Interface Processor or a Shared
Cisco 12000 Series Router SIP and SPA Hardware Installation Guide
4
4-1