Mate Interface Cables; Figure 2-26 Spa Mate Cables - Cisco 12000 - Series Chassis Modular Expansion Base Hardware Installation Manual

Chapter 2 Overview: Cisco 12000 Series Router Shared Port Adapters
Table 2-29 OC-192 Specifications (continued)
Specification
RX Overload
Maximum Receiver Power Damage

Mate Interface Cables

The 1-Port OC-192c/STM-64 POS/RPR XFP SPA supports two mate interface configurations:
•
•
Two 1-Port OC-192c/STM-64 POS/RPR XFP SPAs are connected using a 40–pin connector copper mate
cable. The length of the cables allow only two possible connection scenarios, next slot horizontal and
same slot vertical. This assumes that the chassis is mounted vertically.
used to connect the SPAs.

Figure 2-26 SPA Mate Cables

1
The RPR mate cable is only necessary when the SPA is to be used in RPR mode. It is not needed in POS
Note
mode. Support for the RPR feature is dependent on the platform software release feature content. Verify
support for the RPR feature support via SPA datasheets or by contacting your Cisco representative.
Release 12.0(32)SY1, OL-8831-01, Rev. G6, July 19, 2007
Mate between two OC-192c SPAs in the same SIP
Mate between two OC-192c SPAs in adjacent SIPs
Long length RPR mate cable for single port
RPR SPAs (CBL-RPR-OC192-L)
1-Port OC-192c/STM-64 POS RPR XFP SPA Overview
Description
OC-192 SR-1: –1 dBm
OC-192 IR-2: +2 dBm
OC-192 LR-2: –7.0 dBm
OC-192 SR-1: +5 dBm
OC-192 IR-2: +5 dBm
OC-192 LR-2: +5 dBm
1
2
2 Short length RPR mate cable for single port
RPR SPAs (CAB-RPR-OC192-S)
Cisco 12000 Series Router SIP and SPA Hardware Installation Guide
Figure 2-23 shows the mate cables
2-41