Oc-192 Module Connections; Figure 2-25 Lc-Type Cable For The Xfp Optical Transceiver Modules; Table 2-29 Oc-192 Specifications - Cisco 12000 - Series Chassis Modular Expansion Base Hardware Installation Manual

1-Port OC-192c/STM-64 POS RPR XFP SPA Overview
Use a single-mode optical fiber that has a modal-field diameter of 8.7 ±0.5 microns (nominal diameter
is approximately 10/125 microns) to connect your router to a network.
Figure 2-25
OC-192c/STM-64 POS/RPR XFP SPA.

Figure 2-25 LC-Type Cable for the XFP Optical Transceiver Modules

RX
The 40-pin connector on the 1-Port OC-192c/STM-64 POS/RPR XFP SPA is used for resilient packet
Note
ring (RPR) connections. This feature is not supported in Cisco IOS Release 12.0(31)S.

OC-192 Module Connections

Table 2-29
SPA.

Table 2-29 OC-192 Specifications

Specification
Wavelength
Cabling distance (maximum)
Operating case temperature range
Tx Power
Receiver Sensitivity (maximum)
Cisco 12000 Series Router SIP and SPA Hardware Installation Guide
2-40
shows the cable type for use with the XFP optical transceiver module on the 1-Port
TX
shows the OC-192 specifications for use with the 1-Port OC-192c/STM-64 POS/RPR XFP
Chapter 2 Overview: Cisco 12000 Series Router Shared Port Adapters
/ /
/ / / /
Description
OC-192 SR-1: 1290 nm to 1330 nm
OC-192 IR-2: 1530 nm to 1565 nm
OC-192 LR-2: 1530 nm to 1565 nm
OC-192 SR-1: 2 km (1.2 miles)
OC-192 IR-2: 40 km (24.8 miles)
OC-192 LR-2: 50 miles (80 km)
OC-192 SR-1: 23 to 158 degrees F (–5 to 70 degrees C)
OC-192 IR-2: 23 to 158 degrees F (–5 to 70 degrees C)
OC-192 LR-2: 23 to 158 degrees F (–5 to 70 degrees C)
OC-192 SR-1: –6 dBm –1 dBm
OC-192 IR-2: –1 dBm +2 dBm
OC-192 LR-2: 0 to +4 dBm
OC-192 SR-1: –11 dBm
OC-192 IR-2: –14 dBm
OC-192 LR-2: –24 dBm
Release 12.0(32)SY1, OL-8831-01, Rev. G6, July 19, 2007