Cisco 1601 - Router - EN Hardware Installation Manual page 36

Recommended Practices for Cisco Interface Cards
The following warnings apply in Australia:
Warning Do not touch the power supply when the power cord is connected. For systems with a power switch,
line voltages are present within the power supply even when the power switch is OFF and the power
cord is connected. For systems without a power switch, line voltages are present within the power
supply when the power cord is connected. Statement 4
Before working on equipment that is connected to power lines, remove jewelry (including rings,
Warning
necklaces, and watches). Metal objects will heat up when connected to power and ground and can
cause serious burns or weld the metal object to the terminals. Statement 43
Warning This equipment is to be installed and maintained by service personnel only as defined by AS/NZS 3260
Clause 1.2.14.3 Service Personnel. Statement 88
Warning This equipment will be inoperable when mains power fails. Statement 198
Incorrect connection of this or connected equipment to a general purpose outlet could result in a
Warning
hazardous situation. Statement 212
Because invisible laser radiation may be emitted from the aperture of the port when no fiber cable is
Warning
connected, avoid exposure to laser radiation and do not stare into open apertures. Statemen125
Warning Do not work on the system or connect or disconnect cables during periods of lightning activity.
Statement 1001
To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network
Warning
voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV circuits. Both
LAN and WAN ports may use RJ-45 connectors. Use caution when connecting cables. Statement 1021
Warning Hazardous network voltages are present in WAN ports regardless of whether power to the router is
OFF or ON. To avoid electric shock, use caution when working near WAN ports. When detaching
cables, detach the end away from the router first. Statement 1026
Warning Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
OL-12842-01
4
Installing Cisco Interface Cards in Cisco Access Routers