Cisco 1601 - Router - EN Hardware Installation Manual page 156

Installing Inline Power Daughter Cards on Cisco 10/100BASE-T Ethernet Switch HWICs
Installing a Daughter Card on the HWIC-4ESW Card
To install an inline power daughter card on the HWIC-4ESW card, perform the following steps:
Install the three standoffs (included with the daughter card) on the HWIC motherboard, as shown in
Step 1
Figure
Figure 111
1
2
3
Step 2 Plug the daughter card connector into the motherboard connector, making sure that the standoffs align
correctly underneath the mounting holes in the daughter card.
Step 3 Connect the daughter card to the standoffs with the provided fastening screws. Tighten the screws firmly.
OL-12850-01
4
111, with the provided fastening screws. Tighten the screws firmly.
Installing an Inline Power Card on the Cisco 10/100BASE-T Ethernet Switch
HWIC-4ESW Card
4
5
2
6
3
Fastening screws: daughter card to
standoffs
Standoffs (3)
Fastening screws: standoffs to
motherboard
10/100BASE-T Ethernet Switch High-Speed WAN Interface Cards
1
2 2
4 Daughter card
5 Daughter card connector
6 Motherboard connector