Cisco 1601 - Router - EN Hardware Installation Manual page 170

Installing Small Form-Factor Pluggable Modules into Cisco Gigabit Ethernet High-Speed WAN Interface Cards
Installing Small Form-Factor Pluggable Modules into Cisco
Gigabit Ethernet High-Speed WAN Interface Cards
Small form-factor pluggable modules (SFPs) are hot-swappable Ethernet interfaces that can be installed
directly into the Cisco Gigabit Ethernet high-speed WAN interface card. See
supported on the Cisco Gigabit Ethernet high-speed WAN interface card.
To install an SFP into the Cisco Gigabit Ethernet high-speed WAN interface card, perform the following
steps:
Install the interface card in the router. (See
Step 1
Routers.")
Because invisible laser radiation may be emitted from the aperture of the port when no fiber cable is
Warning
connected, avoid exposure to laser radiation and do not stare into open apertures. Statement 125
Slide the SFP into the housing on the interface card until it is locked into position. (See
Step 2
SFP is designed to prevent improper insertion.
If the SFP uses a bale-clasp latch (see
Tip
top of the SFP in the closed position for proper seating of the SFP module.
Figure 117
1
Caution Do not remove the optical port plugs used on the SFP until you are ready to connect cabling to the
interface card.
To comply with the Telcordia GR-1089 NEBS standard for electromagnetic compatibility and safety,
Caution
connect the Gigabit Ethernet high-speed WAN interface card (HWIC-1GE-SFP) only to intra-building
or non-exposed wiring or cabling. The intrabuilding cable must be shielded and the shield must be
grounded at both ends.
OL-12852-01
4
Installing an SFP on the Cisco Gigabit Ethernet High-Speed WAN Interface Card
C L A
S S 1
L A S
L A S
H W I
E R P
E R P
P R O R O D
C -
R O D
D U IT
U K T
1 G E - P R O
L A S E
D E R
D U C
S F P R D E
T O L
C L A S
A S E
1
R C L
E N
L I N K
1
T X
Optical port plug
Chapter , "Installing Cisco Interface Cards in Cisco Access
Figure 117 and Figure
U C T
K L A
S S E
S E 1 1
A S E
1
R X
G E 0
Gigabit Ethernet High-Speed WAN Interface Cards
Table 34 for SFPs
Figure
118), the bale-clasp handle should be on
117.) The