Cisco 1601 - Router - EN Hardware Installation Manual page 157

10/100BASE-T Ethernet Switch High-Speed WAN Interface Cards
Installing a Daughter Card on the HWIC-D-9ESW Card
To install an inline power daughter card on the HWIC-D-9ESW card, perform the following steps:
Install the four standoffs (included with the daughterboard) onto the HWIC motherboard, as shown in
Step 1
Figure
Figure 112
4
5
1
2
3
Plug the daughter card connectors into the motherboard connectors, making sure that the standoffs align
Step 2
correctly underneath the mounting holes in the daughter card.
Connect the daughter card to the standoffs with the provided fastening screws. Tighten the screws firmly.
Step 3
Verifying Daughter Card Installation
Perform the following steps to verify correct installation of the daughter card:
Install the HWIC into the router and power up the router.
Step 1
Issue the show power inline command.
Step 2
112, with the provided fastening screws. Tighten the screws firmly.
Installing an Inline Power Card on the Cisco 10/100BASE-T Ethernet Switch
HWICD-9ESW Card
2
3
Fastening screws: daughter card to standoffs
Standoffs
Fastening screws: standoffs to motherboard
Installing Inline Power Daughter Cards on Cisco 10/100BASE-T Ethernet Switch HWICs
1
2
2
4 Daughter card connectors
5
Motherboard connectors
4
2
5
OL-12850-01
5