Cisco 1601 - Router - EN Hardware Installation Manual page 149

LAN Interface Cards
WIC-1ENET Requirements
This section describes the requirements and supported standards for the WIC-1ENET card.
WIC-1ENET Memory Requirements
To run Cisco IOS images that support the WIC-1ENET card, the router must have a minimum amount
of Flash memory and dynamic RAM (DRAM). For details on the memory requirements for each image,
refer to Release Notes for the Cisco 1700 Series Routers for Cisco IOS Release 12.2(4)T.
WIC-1ENET Software Requirements
The WIC-1ENET card requires Cisco IOS Release 12.2(2)XJ or later if the card is installed in any WIC
slot other than slot 0 or if more than one card is installed.
The card can be used with Cisco IOS Release 12.2(4)T, but the card must be installed in slot 0 and only
one WIC-1ENET card can be installed in the router.
WIC-1ENET Interface Card Port Numbering
Port numbers identify the interfaces on the modules and interface cards installed in the router. Port
numbers begin at 0 for each slot, and continue from right to left. Modules and interface cards are
identified by interface type, slot number, a forward slash (/), and the port number. For example, E0/0
denotes the first Ethernet port of the interface card installed in slot 0 of the router.
On the Ethernet interface on the Cisco 1720 router is E0. The interface on the WIC-1ENET is addressed
as E1.
On the Cisco 1750 router, the Ethernet interface on the router is E0/0. The interface on the WIC-1ENET
is addressed as E<slot>/1.
WIC-1ENET Interface Card Router Processor Requirements
The MPC 860 microprocessor (revision B5 or later) in the Cisco 1700 series router is required for using
the WIC-1ENET card.
The processor version information is displayed at bootup. You can also verify the processor revision by
entering the show version command at the Cisco IOS command-line interface
WIC-1ENET Supported Standards
The IEEE 802.3 Ethernet standards and 10BASE-T Category 3, 4, and 5 UTP cable distances up to 328
feet (100 meters) are supported.
WIC-1ENET Interface Card
prompt.
Router#
OL-12849-01
5