Cables; Connecting A Dsl Interface Card To The Network - Cisco 1601 - Router - EN Hardware Installation Manual

DSL Interface Cards
Supported Platforms
For a list of the platforms supported by a Cisco interface card refer to
Interface
Finding Support Information for Platforms and Cisco IOS Software Images
Use Cisco Feature Navigator to find information about platform support and Cisco IOS software image
support. Access Cisco Feature Navigator at http://www.cisco.com/go/fn. You must have an account on
Cisco.com. If you do not have an account or have forgotten your username or password, click Cancel at
the login dialog box and follow the instructions that appear.

Cables

The twisted-pair straight-through cable for customer premises equipment (CPE) applications is supplied.
The RJ-45-to-RJ-45 BRI cable to connect the ISDN BRI ports on ADSLoISDN HWICs is not supplied.
The two-line Y-cable for central office (CO) and 4-wire patch panel applications is not supplied.
Note The Y-cable must have the wires for pins 3 and 4 twisted together; wires for pins 2 and 5 must also be
twisted together. Each pair goes to its own connector at the patch panel end.

Connecting a DSL Interface Card to the Network

See the following sections for information on connecting DSL interface cards to a network.
•
•
•
Connecting the DSL Ports on WICs and HWICs
Use a straight-through RJ-11 cable for this connection.
Table 19
Table 19
Pin
3
4
If you are connecting an ADSL interface card to an RJ-11 wall jack that has the DSL pair wired for pins
Note
2 and 5, you must use an RJ-11 crossover cable (lavender with blue stripe). The RJ-11 crossover cable
is orderable separately as a spare.
Cards.
Connecting the DSL Ports on WICs and HWICs, page 9
Connecting the ISDN Ports on HWICs, page 12
Connecting the SHDSL Port on the G.SHDSL HWICs, page 12
shows the ADSL WIC and HWIC pinouts.
ADSL WIC and HWIC Pinouts
Signal
Tip
Ring
Cables
Platform Support for Cisco
OL-12846-01
9