Cisco 1601 - Router - EN Hardware Installation Manual page 107

DSL Interface Cards
Connect the other end to the wall jack (RJ-11) at your site, as shown in
Step 3
Figure 68
ADSL port
(RJ-11)
ADSL
RJ-11 twisted-pair cable
Alternately, when connecting a G.SHDSL card to a 4-wire patch panel, use a Y-cable as shown in
Figure 69.
Figure 69
SHDSL port
WIC
1SHD SL V2
Step 4 Turn on power to the router.
To connect the card to the network, you must configure the DSL interface card in the router to the no
Step 5
shutdown state. Enter the no shut command in the router configuration. Verify that the CD LED comes
on, indicating that the interface card is connected to the network.
Step 5 does not apply to the WIC-1SHDSL-V2 or WIC-1SHDSL-V3.
Note
Connecting an ADSL Card to the Wall Jack
SEE MANU AL
BEFO RE INSTA LLAT ION
CD
LP OK
wall jack
Connecting a G.SHDSL Card to a Patch Panel With a Y-Cable
(RJ-11)
SEE MANU AL
BEFO RE INSTA LLATI ON
CD
SHDS L LP
OK
RJ-11
twisted-pair
cables
RJ-11
Patch panel
10
11
12
13
Connecting a DSL Interface Card to the Network
Figure 68.
14
OL-12846-01
11