Cisco 1601 - Router - EN Hardware Installation Manual page 15

Cisco Interface Cards for Cisco Access Routers
Table 2 Cabling for Cisco Interface Cards
Technology
Connector Type, Cable
Connection Type Color
Gigabit Ethernet, RJ-45
copper
Gigabit Ethernet, LC, color according to
optical optical wavelength
A single fiber
Note
link should not
mix 62.5- and
50-micron
cable.
ISDN Connections
BRI S/T RJ-48C
(external NT1)
BRI S/T RJ-45
(external NT1)
BRI U RJ-49C/CA-A11, red
(built-in NT1)
56/64 kbps DSU/CSU 8-pin modular, blue
T1/fractional T1 RJ-48C
DSU/CSU
Serial Connections
Synchronous serial 60-pin D, blue
Serial 26-pin Cisco Smart
serial
68-pin
Cable
1000BASE-T Category 5 or above UTP
Optical fiber as specified on applicable
data sheet
RJ-48C straight-through
RJ-45 Straight-through
RJ-11; RJ-21 if using NM-HDA,
straight-through
RJ-48S straight-through
RJ-48C straight-through
Serial transition cable (EIA/TIA-232,
EIA/TIA-449, EIA/TIA-530 DTE, V.35,
X.21, NRZ/NRZI)
Cisco Smart serial interface cable (see
Table 3)
Cisco 4-port RS-232 DCE or DTE cable
assembly (two cable assemblies are
required for each HWIC-8A/S-RS232)
Cisco 8-port RS-232 DTE cable assembly
(two cable assemblies are required for
each HWIC-16A)
Cabling for Cisco Interface Cards
Use with
HWIC-1GE-SFP (through
SFP)
WIC36-1B-S/T
WIC-1B-S/T
WIC-1B-S/T-V3
WIC-1B-S/T-LL
HWIC-ADSL-B/ST
HWIC-ADSLI-B/ST
WIC36-1B-U
WIC-1B-U
WIC-1B-U-V2
WIC-1DSU-56K4
WIC-1DSU-T1
WIC-1DSU-T1-V2
WIC-1T
HWIC-4A/S
HWIC-4T
WIC-2A/S
WIC-2T
HWIC-8A/S-RS232
HWIC-8A
HWIC-16A
OL-12796-01
13