Table of Contents
Advertisement
Battery Installation
To install batteries in the base station, complete the following:
a
Only install batteries in a fresh air environment. Do not
install batteries in a hazardous area. Failure to adhere to
this warning can result in personal injury and/or property
damage.
Use only alkaline C-size batteries; do not use
rechargeable batteries in the MicroDock II.
1.
Loosen the retaining screws from the battery cover.
Do not remove the screws from the cover.
2.
Remove the battery cover and insert four C-cell bat-
teries into the battery compartment.
3.
Replace the battery cover and tighten the retaining
screws. Do not overtighten.
Mounting the MicroDock II Base Station and Docking
Modules
For wall mounting instructions, refer to the MicroDock II Base
Station User Manual.
Warning
Inserting the Detector
a
Infrared or intense ambient light (sun or halogen) may
interfere with the base station/detector communication.
To insert a detector into a docking module, complete the follow-
ing:
1.
Activate the detector and wait until it is in normal
operation.
2.
Ensure the alligator clip is closed and the ring is rest-
ing flat on the detector.
3.
Press the two release tabs on the docking module
and open the lid.
•
If inserting the GasAlertMax XT / GasAlertMax
XT II, move the pump connector up.
4.
Refer to the following sections to insert the detectors
into the docking modules.
GasAlertClip Extreme / GasAlert Extreme
• Lower the detector (serial number face up) into the
detector bay.
• Push forward to ensure the top of the detector connects
with the top of the bay.
• Close the lid and press until the release tabs click.
• When the detector has been inserted correctly, the RUN
LED(s) on the docking module light yellow and Unit
Inserted displays on the base station LCD. The base
MicroDock II
Inserting the Detector
Caution
7
Advertisement
Table of Contents
