Table of Contents
Advertisement
For more information, refer to the MicroDock II Base
Station User Manual.
To charge the battery pack, complete the following:
1.
Connect the charger adaptor cord into the CHARGE
port on the station, and then plug into an AC outlet.
The CHARGE LED briefly lights red then green
during the self-test. The LED then powers off (not
applicable to the GasAlertMicroClip / GasAlertMicro-
Clip XT, GasAlertMax XT / GasAlertMax XT II, and
GasAlertQuattro modules).
2.
Deactivate the detector. Insert the detector into the
charging cradle.
3.
The CHARGE LED lights red (all charging modules).
4.
Allow the battery to obtain a full charge (2 to 4 hours,
depending upon how many docking modules are con-
nected to this station).
If a docking module is in queue waiting to charge, the
CHARGE LED flashes red.
When the docking module begins charging, the
CHARGE LED stops flashing and lights solid red.
The CHARGE LED lights green when the charging
process is complete. If there are other docking mod-
ules in queue, waiting to charge, they will begin
charging.
The CHARGE LED deactivates when the detector is
removed.
Maintenance
a
No user-serviceable parts inside.
a
Confirm that the inlet filter is free of dirt and replace if
required. To order replacement parts, refer to
Replacement Parts and Accessories in the MicroDock II
Base Station User Manual.
To maintain the station in good operating condition, perform the
following basic maintenance as required.
• Clean the exterior with a soft, damp cloth. Do not use sol-
vents, soaps, or polishes.
• Do not immerse the station in liquids.
MicroDock II
Maintenance
Warning
Caution
17
Advertisement
Table of Contents
