Table of Contents
Advertisement
MicroDock II
Quick Reference Guide
Bump Test
A bump test is performed to confirm that the detector is
responding to gas, and that the audio and visual alarms are
operational.
During the bump test, event logs from the GasAlertClip
Extreme, GasAlert Extreme, GasAlertMicroClip / GasAlertMi-
croClip XT, GasAlertMax XT / GasAlertMax XT II, and
GasAlertQuattro are transferred to the MMC.
There are different bump tests available for the GasAlertMax
XT / GasAlertMax XT II and GasAlertQuattro. Refer to the
detector's Configuration Options section in the Safety Suite
Device Configurator (SSDC) Operator's Manual.
a
Ensure the detector is not in a low battery state prior to
performing a bump test.
The base station cannot perform a bump test for O
and ClO
sensors.
2
12
Caution
Note
To perform a bump test, complete the following:
1.
From the docking module of the applicable detector,
press C BUMP CHECK.
2.
The gas is automatically applied.
3
Advertisement
Table of Contents
