Battery Warm-Up Time; Touchconfig: Bringing Additional A700 Devices Online - Honeywell Vocollect Talkman A700 Product Manual

18 | Vocollect Talkman A700 Product Guide
3. Lift the battery out of the compartment.

Battery Warm-Up Time

If a battery has been used in a cold environment, it will not begin charging until it warms up sufficiently.
Temperature of battery use
-4°C (24.8°F)
-10°C (14.0°F)
-20°C (-4°F)
-30°C (-22°F)

TouchConfig: Bringing Additional A700 Devices Online

Prerequisite: A single device has been configured. The following instructions are for configuring additional
devices.
Note: TouchConfig uses near field communication (NFC). Data sent through NFC is not encrypted nor
does it follow any specific safety protocol. This is because the transfer occurs over such a short range
that it is nearly impossible for data to be intercepted.
1. Ensure that all devices are off.
2. On the configured device, press and hold the Plus (+) button then press the Play/Pause button to put the
device into sender mode.
The ring's small segment will be solid yellow and the NFC indicator will blink yellow.
3. On the unconfigured devices, press and hold the Minus (-) button then press the Play/Pause button to
put the devices into receiver mode.
The ring's large segment will be solid yellow and the NFC indicator will blink yellow.
4. Turn each of the unconfigured devices so that the sides with the
5. Hold the configured device so that the side of the device that has the
raised oval on the device with the raised oval on an unconfigured device. Ensure that the ovals are fully
aligned, then hold the two devices steadily against each other.
Confidential: For informational use by Honeywell resellers and customers only
Figure 3: Removing the Battery From a Device
Approximate warm-up time
6 minutes
10 minutes
22 minutes
30 minutes
symbol are facing up.
symbol is facing down. Align the