Collecting Platform Debug Logs From A700 Devices; Cleaning Procedures For Honeywell Equipment; Cleaning Plastics - Honeywell Vocollect Talkman A700 Product Manual

Collecting Platform Debug Logs from A700 Devices

When you connect an A700 device to your Windows PC, the PC will search for a USB driver to install. If the
PC is configured to search for drivers online and the connection succeeds, the driver will install automatically
and the A700 device will be ready to use. If the automatic installation fails, follow these steps.
1. Using a standard USB cable, connect the device to a computer.
2. Power on the device.
3. On your computer, run a serial terminal emulator, such as HyperTerminal, using the following settings:
• Bits per Second: 57600
• Data Bits: 8
• Parity: None
• Stop Bits: 1
• Flow Control: None
The device transfers platform logs 30 seconds after connection and then once a minute after that. The results
are viewable within the serial terminal emulator window.

Cleaning Procedures for Honeywell Equipment

Honeywell Vocollect Solutions products have a long service life if they are maintained properly. Follow
recommended cleaning practices.
While Honeywell equipment is manufactured and tested to be resistant to normal dirt and deposits from the
workplace environment, the build-up of residue can damage the equipment and degrade performance over
time.
• Dirt or corrosion can prevent the proper seating of terminals in chargers and may cause intermittent
charging.
• Talkman Connector (TCO) contacts that build up dirt, chemicals, and corrosion may cause intermittent
®
contact, static, and recognition problems.
• Excessive dirt on a keypad membrane can cause the membrane to weaken and tear.
Caution: Use only a solution of 70% isopropyl alcohol and water to clean equipment. Other products
have not been tested and may degrade the equipment.

Cleaning Plastics

Cleaning Hard Plastics
Clean the hard plastics on headsets, devices, chargers, and batteries with a soft cloth that is wet with a
solution of 70% isopropyl alcohol and 30% water.
Use a soft brush to keep the pocket areas of chargers free of dust and debris that may interfere with the
seating of equipment or electrical contact.
Cleaning Foam and Pliable Plastics
Clean headset foam parts (ear pads and headband pads) as well as flexible bands and non-foam padding
with a mild soap and water. Wash pads carefully so as not to tear or detach them.
Confidential: For informational use by Honeywell resellers and customers only
Using the Talkman A700 Device | 29