Honeywell Vocollect Talkman A700 Product Manual page 50

50 | Vocollect Talkman A700 Product Guide
Error Message
"Firmware error while changing task. Task
not changed."
"Flash error."
"Flash is full. Please wait while Talkman
turns off."
"Headset battery is getting low."
"Headset battery is getting low. Change
headset battery now."
"Initializing operator failed. Please reload
operator."
"Internal error loading operator."
"Invalid operator file name."
"Invalid device Manager Host name or
address."
"Invalid device Manager Service name or
port."
"No task list file found. Task unchanged."
"Noise sampling procedure failed."
Confidential: For informational use by Honeywell resellers and customers only
Solution
4. Reload VoiceClient.
1. Reload the task.
2. Turn the device off and then turn it back on again.
3. Reboot the device.
4. Reload VoiceClient.
1. Turn the device off and then turn it back on again.
2. Reboot the device.
3. Reload VoiceClient.
1. Go to an area of known good coverage.
2. Turn the device off and then turn it back on again.
3. Reboot the device.
4. Reload VoiceClient.
Change the battery.
Change the battery.
1. Reload the operator.
2. Turn the device off and then turn it back on again.
3. Reboot the device.
4. Reload VoiceClient.
1. Turn the device off and then turn it back on again.
2. Reboot the device.
3. Reload VoiceClient.
Select the operator again or load a different operator.
1. Reload the task.
2. Turn the device off and then turn it back on again.
3. Reboot the device.
4. Reload VoiceClient.
1. Sample noise again.
2. Go to a quieter location and perform another noise sample.
3. Try using another headset and perform the noise sample.
Note: If this solves the problem, the first headset might be
damaged.