Turning A Talkman Device On; Turning A Talkman Device Off - Honeywell Vocollect Talkman A700 Product Manual

6. Watch the device state LED indicator ring on the receiving device to confirm configuration success or
failure.
Successful configuration transfer: The receiving device LED indicator ring blinks green for about two
seconds, then the indicator signals the device reboot process (flashes red briefly, then rotates yellow
around the ring, then rotates red).
Failed configuration transfer: The LED indicator ring blinks red for about two seconds, then returns to
receiver mode.
7. Repeat steps 5 and 6 for any remaining unconfigured devices.

Turning a Talkman Device On

Before you turn on a device, make sure a headset and charged battery are properly connected to it.
1. Press the Play/Pause button on the device.
The LED indicator differs depending on the device being used.
Device Type
A700 series
T2 series, T5 series and A500
T1
2. The device says, "Current operator is operator name. Please keep quiet for a few seconds." The device
then starts a noise sample.
3. After a brief pause, it says, "Please wait." After another pause, the device begins asking questions or
providing instructions.

Turning a Talkman Device Off

Use a button control to properly power off the Talkman device. In some cases, the device turns off automatically.
In rare cases, a forced reset may be necessary. After the device is fully turned off, you can reboot it.
Figure 4: Transferring the Configuration Using TouchConfig
Confidential: For informational use by Honeywell resellers and customers only
Using the Talkman A700 Device | 19
Indicator
The ring is yellow and rotates, then the ring segment
turns solid green.
First turns solid red while the processor reboots. It
then flashes red and green, turns solid, blinks red,
then turns solid green.
Turns solid green