Network Parameters; Dhcp - Cisco ATA 186 Administrator's Manual

Chapter 5 Parameters and Defaults
If the Cisco ATA configuration file is not encrypted, the value must be set to 0.
Note
Value Type
Alphanumeric string
Range
Maximum number of characters: 8
Default
0
Voice Configuration Menu Access Code
320
Related Parameters
•
•

Network Parameters

This section describes the parameter for enabling or disabling the use of a DHCP server to obtain IP
address information, and parameters that you need to statically configure if you disable DHCP:
•
•
•
•

DHCP

Description
A DHCP server can be used to automatically set the Cisco ATA IP address, the network route IP address,
the subnet mask, DNS, NTP, TFTP, and other parameters.
•
•
Value Type
Boolean
Range
0 or 1
OL-4008-01
UseTFTP, page 5-5
TftpURL, page 5-5
DHCP, page 5-7
StaticIp, page 5-8
StaticRoute, page 5-8
StaticNetMask, page 5-9
1—Enable DHCP
0—Disable DHCP
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide (H.323)
Network Parameters
5-7