Using The Cisco Ata With An H.323 Gatekeeper; Choosing Cisco Ata Registration Mode With An H.323 Gatekeeper - Cisco ATA 186 Administrator's Manual

Cisco analog telephone adaptor administrator's guide
Hide thumbs Also See for ATA 186:
Table of Contents

Advertisement

Chapter 4
Basic and Additional H.323 Services
Setting Up User IDs for the Cisco ATA
Each Cisco ATA can support two FXS ports. You can assign a user ID, which is usually an E.164 phone
number, to each port. Use the Cisco ATA parameter UID0 to configure an ID for the Phone 1 port, and
use the UID1 parameter for the user ID of the Phone 2 port.
Related Configuration Parameters

Using the Cisco ATA with an H.323 Gatekeeper

The Cisco ATA can function with an H.323 gatekeeper to enable Cisco ATA registration, admission, and
use of directory services on an H.323 network. To use the Cisco ATA with a primary H.323 gatekeeper,
you need to configure the GkOrProxy parameter with the IP address assigned to the primary H.323
gatekeeper. Optionally, you can specify the primary gatekeeper identifier using the GkId parameter if
this identifier is required for the Cisco ATA to successfully register with the H.323 network.
This section contains the following topics:
Related Configuration Parameters

Choosing Cisco ATA Registration Mode with an H.323 Gatekeeper

The Cisco ATA can register with an H.323 gatekeeper in one of two modes:
To configure single-mode registration, you need to set the UseLoginID parameter to 1, and then
configure the LoginID1 and LoginID2 parameters with identical values. The LoginID1 and LoginID2
parameters are used for the H.323 ID, whereas the UID0 and UID1 parameter values are used as E.164
phone numbers.
OL-4008-01
UID0, page 5-10
UID1, page 5-11
Choosing Cisco ATA Registration Mode with an H.323 Gatekeeper, page 4-3
Setting Up Gatekeeper Time-To-Live Value, page 4-4
Setting Up an Alternate H.323 Gatekeeper, page 4-4
Establishing Authentication with Cisco H.323 Gatekeeper, page 4-5
GkOrProxy, page 5-15
GkId, page 5-17
Single registration—Both Cisco ATA FXS ports register at the same time with the H.323 gatekeeper.
This reduces gatekeeper registration traffic by 50 percent when both ports are enabled.
Dual registration—Each FXS port registers separately with the H.323 gatekeeper.
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide (H.323)
Important Basic H.323 Services
4-3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ata 188

Table of Contents