Cisco ATA 186 Administrator's Manual page 141

Chapter 7 Configuring and Debugging Fax Services
An example debug log for a terminating gateway scenario is show below:
[0]Tx MPT PT=100 NSE pkt c0000000
[0]codec: 4 => 0
[0]Rx MPT PT=100 NSE pkt c0000000
The NSE response to the CED tone event is not mandatory; some gateways may not send back an NSE
Note
response.
Originating-Gateway Example
When the Cisco ATA is used as an originating gateway for a fax session, make sure that the following
conditions are true:
•
•
•
An example debug log for an originating gateway scenario is shown below:
[0]Rx MPT PT=100 NSE pkt c0000000
[0]Tx MPT PT=100 NSE pkt c0000000
[0]codec: 4 => 0
[0]Rx MPT PT=100 NSE pkt c0000000
[0]Rx MPT PT=100 NSE pkt c0000000
If your gateway is using a legacy IOS software image, it may not send NSE packets but instead may rely
Note
on a straightforward codec switchover mechanism. In this case, a codec switchover event occurs rather
than an NSE packet transaction.
Possible Reasons for Failure
If your Cisco ATA does not receive CED-tone-event NSE packets and codec switchover does not occur,
the failure may be due to the following reasons:
•
•
If the log shows proper NSE packet transaction and G.711 upspeed for your fax session but the session
still fails, check that the following conditions are true:
•
•
•
Debugging FAX Mode
When the Cisco ATA is configured with fax mode, only G.711 codecs are used. You must confirm that
only 0 (for G.711µ-law) or 8 (for G.711A-law) appear in the
The following example of a debug log shows that G.711µ-law is used:
[0]Enable encoder 0
[0]DPKT 1st: 1491513359 1491512639, pt 0
OL-4008-01
The Cisco ATA receives and responds to CED-tone-event NSE packets.
The NSE payload type is the same for the received and transmitted NSE packets.
The encoder switchover to G.711 occurs during NSE-packet transaction.
The terminating gateway is not configured with fax/modem pass-through.
The fax pass-through mode used by the terminating gateway may not be compatible with the Cisco
NSE method.
The Cisco ATA software image version is 2.14 or above.
The Cisco ATA model number is ATA186-I1, ATA186-I2, ATA188-I1, or ATA188-I2.
The fax relay option for the remote gateways has been disabled.
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide (H.323)
Debugging the Cisco ATA 186/188 Fax Services
and
Enable encoder DPKT 1st
debug lines.
7-11