Debugging - Cisco ATA 186 Administrator's Manual

Debugging

Symptom
executable-file upgrade method.
Possible Cause
Recommended Action
Symptom
executable-file upgrade method.
Possible Cause
Recommended Action
Possible Cause
Recommended Action
Symptom
Possible Cause
Recommended Action
Symptom
Possible Cause
Recommended Action
Debugging
The MS-DOS Windows-based debugging program tool, preserv.exe, is included in every software
upgrade package. The tool is also available from Cisco TAC. The prserv program is used in conjunction
with the NPrintf configuration parameter. This file serves as an upgrade server that captures debug
information sent by the Cisco ATA software to your PC's IP address and port number. This debug file
(prserv.exe) compiles the information from the Cisco ATA into a readable log file. To capture this
"NPRINTF" information, you must know the IP address of the PC using the prserv program, illustrated
as follows:
IP address.port
where IP address is the IP address of your PC, and port is 9001. If another process on your PC already
uses port 9001, you may use some other value (legal values are from 1024 to 65535). If no port value is
entered, the default value is 9001.
To enter the IP address and port number, use voice menu option 81#. You must enter the IP address and
port number in alphanumeric format, which requires entering the * key after every character entered. To
enter the "." character, you must enter the sequence 1 1#.
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide (H.323)
9-4
Voice prompt returns Upgrade not available message. This can only occur if you are using the
You are attempting to upgrade to the existing version.
You do not need to upgrade.
Voice prompt returns Upgrade failed message. This can only occur if you are using the
You have entered an incorrect IP address.
Enter the correct IP address.
Software image is corrupted.
Upgrade software image.
No dial tone.
No user ID was entered.
Enter the correct user ID.
Incorrect dial tone.
Check the web interface for your DialTone setting. The default is U.S.
Set the correct country DialTone value.
Chapter 9 Troubleshooting
OL-4008-01