Dns1Ip; Dns2Ip; Udptos - Cisco ATA 186 Administrator's Manual
Cisco analog telephone adaptor administrator's guide
Hide thumbs
Also See for ATA 186:
- Administrator's manual (218 pages) ,
- Installation and configuration manual (13 pages) ,
- User manual (12 pages)
Table of Contents
Advertisement
Chapter 5
Parameters and Defaults
Related Parameters
•
•
DNS1IP
Description
This parameter is the primary domain name server (DNS) IP address, if the DHCP server does not
provide one. If DHCP provides DNS, DNS1IP and DNS2IP (if they are non-zero) overwrite the
DHCP-supplied values. The user must not specify a port parameter. The Cisco ATA uses the default DNS
port only.
Value Type
IP address
Default
0.0.0.0
Voice Configuration Menu Access Code
916
DNS2IP
Description
This parameter is the secondary domain name server (DNS) IP address, if the DHCP server does not
provide one. If DHCP provides DNS, DNS1IP and DNS2IP (if they are non-zero) overwrite the
DHCP-supplied values. The user must not specify a port parameter. The Cisco ATA uses the default DNS
port only.
Value Type
IP address
Default
0.0.0.0
Voice Configuration Menu Access Code
917
UDPTOS
Description
This parameter specifies the IP precedence (ToS bit) of UDP packets. Set the lower eight bits only, as
follows:
•
•
OL-4008-01
NTPIP, page 5-30
TimeZone, page 5-29
Bits 0-1: Unused
Bit 2: Reliability bit—1=request high reliability
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide (H.323)
Operating Parameters
5-31
Advertisement
Table of Contents
