Connectmode - Cisco ATA 186 Administrator's Manual

Operating Parameters
Default
0x00000000
Voice Configuration Menu Access Code
304

ConnectMode

Description
This parameter is a 32-bit bitmap used to control the connection mode of the selected call signaling
protocol.
Value Type
Bitmap
Default
0x00060400
Voice Configuration Menu Access Code
311
Table 5-4 ConnectMode Parameter Bit Definitions
Bit Number Definition
0 0—Use slow-start procedure (for H.225/Q.931 and H.245).
1—Use fast-start procedure (for H.225/Q.931).
1 0/1—Disable/enable h245 tunneling.
2 0—Use the dynamic payload type 126/127 as the RTP payload type (fax pass-through mode) for G.711
µ-law/G.711 A-law.
1—Use the standard payload type 0/8 as the RTP payload type (fax pass-through mode) for G.711
µ-law/G.711 A-law.
3 0—Do not perform full gatekeeper registration when the Cisco ATA switches to an alternate H.323
gatekeeper.
1—Perform full gatekeeper registration when the Cisco ATA switches to an alternate H.323 gatekeeper.
4 0—Denotes a non-Cisco CallManager environment.
1—Enable the Cisco ATA to operate in a Cisco CallManager environment.
5 0/1—Enable/disable two-way cut-through of voice path before the Cisco ATA receives the CONNECT
message.
6 0/1—Disable/enable using the Progress Indicator to determine if ringback is supplied by the far end with
RTP.
7 0/1—Disable/enable fax pass-through redundancy.
8-12 Specifies the fax pass-through NSE payload type. The value is the offset to the NSE payload base number
of 96. The valid range is 0-23; the default is 4.
For example, if the offset is 4, the NSE payload type is 100.
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide (H.323)
5-28
Table 5-4 on page 5-28 provides bit definitions for this parameter.
Chapter 5 Parameters and Defaults
OL-4008-01