Web Interface Access-Control Configuration; Refreshing Or Resetting The Cisco Ata - Cisco ATA 186 Administrator's Manual

Web Interface Access-Control Configuration

You can access the web configuration page from any graphics-capable browser, such as
Microsoft Internet Explorer or Netscape. This provides easy initial access to the Cisco ATA
configuration within the administrator's private network.
Follow these steps to set parameters using the web configuration page:
Procedure
Make sure that your PC and the Cisco ATA are already networked and visible to each another.
Step 1
Step 2 Open your web browser.
Step 3 Enter the URL for your configuration page. The default URL for the web server is:
http://IP Address/dev
For example, the configuration page for a Cisco ATA with the IP address 192.168.3.225 is:
http://192.168.3.225/dev
Select the values for the items that you want to configure. See
Step 4
a complete list of parameters and their definitions. Also see
listing of configurable features and references to their corresponding parameters.
Note Cisco strongly recommends that you set a password. Use the UIPassword parameter to configure a
password, after which you are prompted for the password whenever you attempt to change a parameter
value. Configuration parameters cannot be accessed through the voice configuration menu if the
password contains one or more letters and can be changed only by using the web interface or the TFTP
configuration method.
Click apply to save your changes.
Step 5
The Cisco ATA automatically refreshes its configuration.
Close your web browser.
Step 6
Web Interface Access-Control Configuration
To prevent tampering and unauthorized access to the Cisco ATA configuration, the Cisco ATA built-in
web server can be disabled by using the OpFlags parameter.
Related Parameter
OpFlags, page

Refreshing or Resetting the Cisco ATA

Whenever you make configuration changes to your Cisco ATA configuration file, you can refresh or reset
the Cisco ATA for these configuration changes to immediately take effect. If you do not refresh or reset
the Cisco ATA, the configuration changes will take effect the next time the Cisco ATA contacts the TFTP
server, which occurs based on the configured value of the CfgInterval parameter (see the
the Cisco ATA Refresh Interval" section on page
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide (H.323)
3-20
5-33—Bit 7
Chapter 3 Configuring the Cisco ATA for H.323
Chapter 5, "Parameters and Defaults,"
Table 4-4 on page 4-12
4-9).
for
for an alphabetical
"Configuring
OL-4008-01