Resetting The Cisco Ata To Factory Default Values; Cisco Ata Web Configuration Page - Cisco ATA 186 Administrator's Manual

Cisco ATA Web Configuration Page

Resetting the Cisco ATA to Factory Default Values

It is possible that you may, under some circumstances, want to reset the Cisco ATA to its factory default
values. For example, this is the only way to recover a forgotten password without contacting your Cisco
representative.
To perform a factory reset, you must use the voice configuration menu and follow these steps:
Procedure
Press the function button on the Cisco ATA.
Step 1
Press the digits 322873738 (FACTRESET) then press # on your telephone keypad.
Step 2
Press 3 on your telephone keypad to confirm that you want to reset the Cisco ATA, then hang up the phone.
Step 3
Cisco ATA Web Configuration Page
You can use the Cisco ATA web configuration page in a non-TFTP configuration environment, or in a
TFTP configuration environment as a read-only record of individual customer parameters.
You can display the most recent Cisco ATA configuration file from the TFTP server by opening your web
browser and typing the following:
http://<ipaddress>/refresh
where ipaddress is the IP address of the Cisco ATA.
Figure 3-1
configurable parameters.
Do not use the web configuration page to attempt to change any values that you configured by means of
Note
the TFTP configuration file method. Whenever the Cisco ATA refreshes, it downloads its
ata<macaddress> configuration file or atadefault.cfg default configuration file from the TFTP server,
and the values in either of these files will overwrite the values of any corresponding parameters
configured with the web configuration method.
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide (H.323)
3-18
shows and example of the Cisco ATA web configuration page, which displays all
Chapter 3 Configuring the Cisco ATA for H.323
OL-4008-01