Operation Mode Behavior - Honeywell SILENT KNIGHT RPS-2000 Installation And Operation Manual

to begin communication.
5. The panel will attempt to communicate with the computer. If communication was estab-
lished, the upload task you created will be placed in the SKSS-2 job queue, awaiting pro-
cessing. When processing is completed, an "Unsolicited Upload" task will appear in the
queue.

10.5 Operation Mode Behavior

The control panel can be in one or more of seven conditions at any given moment: Normal,
Alarm, Prealarm, Supervisory, Trouble, Silenced, and Reset. Table 10-1 describes the
behavior of the panel in each of these modes.
Operation
Occurs When
Mode
Normal No alarm or
trouble
condition exists
and menus are
not in use.
Alarm A smoke
detector goes
into alarm or a
pull station is
activated.
151430
Table 10-1 Operation Mode Behavior
System Behavior
SYSTEM POWER LED is on.
The All Systems Normal display indicates
that the system is in normal mode.
The current date and time display on the
last line of the LCD.
The dialer seizes control of the phone line
and calls the central station.
The on-board annunciator sounds a loud,
steady beep (any notification devices
attached to the system will also sound).
GENERAL ALARM LED is on.
The LCD displays a screen similar to this
one.
firealarmresources.com
System Operation
In This Mode You Can
Enter the appropriate code to activate the User or
Installer Menu.
Press the down arrow to view the alarm. A screen
similar to this one displays.
Press to silence the annunciator (and any
notification devices attached to the system).
When the alarm condition clears, press
restore the panel to normal.
to
10-11