Honeywell SILENT KNIGHT RPS-2000 Installation And Operation Manual page 43

2. Connect the main control panel battery cables to the battery cable extenders as shown in
Figure 4-5.
Figure 4-5 Splicing Control panel Battery Cable to RBB or AB-55 Battery Cable Extenders
3. Run extended battery cable from control panel cabinet through conduit to RBB or AB-55
cabinet.
See Figure 4-6.
Conduit
Coupler
Conduit
Figure 4-6 Battery Connections in the RBB or AB-55 Cabinet
Note: Figure 4-6 is an example of how the wire connections can be routed. However, any other cabinet knock-
outs (on either the main control panel or the RBB/AB-55 cabinet), that are not previously being used may
be utilized to connect conduit between the two cabinets.
4. Connect battery leads to the backup battery terminals. See Figure 4-6.
Observe the proper polarity to prevent damage to the batteries or the control panel.
5. Insert the RBB or AB-55 cover screws into the cover mounting holes (see Figure 4-6).
Screw the cover screw 3/4 of the way into the cover mounting hole.
151430
RBB/AB-55 Cabinet
Cover Screws
-
+
RBB/AB-55 Cabinet
Cover Screws
firealarmresources.com
Control Panel Installation
-
+
4-5