Iq8 Panels; To Use An Rs-485 Connection - Honeywell CGW-MB Installation And User Manual

ESSER Panels

IQ8 Panels

To Use an RS-485 Connection

Using an RS-485 cable, you can connect to the additional RS-485 module (784871) on
the panel's serial interface port.
The RS-485 ports in the CLSS Gateway mainboard board are labeled as 3 and 4 in the
Figure C.2.
On the Panel Side
Using an SEI2 Card Connect to the RS-485 (784871) module in the panel as below:
In the RXD port of the panel's SEI-2 card:
• Connect the In+ wire to the RXD+ pin.
• Connect the In- wire to the RXD- pin.
Power Connection
Using a power cable, the CLSS Gateway mainboard can connect to the 12V DC power
supply module of the panel.
NOTE: Although the CLSS Gateway mainboard is capable of receiving 24V DC power, it
can work with the 12V DC power of the IQ8 panel. Ensure that the power supply to the
CLSS Gateway mainboard is within +12V DC power.
On the CLSS Gateway mainboard Side
• Connect the +ve wire to the +ve pin of the power supply port.
• Connect the -ve wire to the -ve pin of the power supply port.
On the Panel Side
• Connect the +ve wire to the +UBext pin of the SEI-2 card.
• Connect the -ve wire to the GND pin of the SEI-2 card.
CGW-MB Installation and Users' Manual | P/N:LS10248-000HW-E | REV.G | JUL/31/2022
Figure C.9: Wiring Diagram: RS-485 to SEI2 Connection
Connecting to the Panels
147