Bandwidth Calculation; Requirements For The Calculation - Honeywell CGW-MB Installation And User Manual

Bandwidth Calculation

7.6 Bandwidth Calculation
Use the following information to calculate the network bandwidth CGW-MB usage
requires and how it will impact the network.
For TCP Request
Ethernet Header
IP Header
TCP Header
MBAP Header
Message—5 bytes Function code (1) + Start Address (2) + Quantity of Registers (2)
Total Bytes
For TCP Response
Ethernet Header
IP Header
TCP Header
MBAP Header
Message—Function code (1) + Byte Count (1) + Max 100 registers of each
2 Bytes (200)
Total Bytes

Requirements for the Calculation

• One request and response pair requires 329 Bytes (66 + 263).
• If a client is polling at one second intervals, then request and response are both
possible in one second.
• A request and response pair creates network traffic of 329 Bytes per second (329 x 1).
• In other words, a request and response pair creates network traffic of 2632 bits per
second (329 x 8).
• Therefore, the network must be able to accommodate at least 0.0027 Mbps data flow.
• Once every five seconds, an analog request adds a small amount of network traffic.
• Formula for CGW-MB network bandwidth requirement based on polling rate:
Bandwidth Requirement = (329 x (1000/polling rate in milliseconds) x 8) / (10 ^ 6) Mbps
CGW-MB Installation and Users' Manual | P/N:LS10248-000HW-E | REV.G | JUL/31/2022
Table 7.2: Total Required Bandwidth
Description
Description
Modbus Communications
Bytes
14
20
20
7
5
66
Bytes
14
20
20
7
202
263
39