Hitachi UX Twin-Nozzle Technical Manual page 146

Open the "Circulation control" screen, and press the
1
Process prior to long-term shutdown key and the Start/Continue key.
Circulation control
(Goes to Standby)
Nozzle 1 backwash
Ink replacement
Process prior to
long-term shutdown
Select option; press [Start/Cont.]
The following guidance appears. Confirm the message and Press
2
Start/Continue key.
Circulation control
Process : Process prior to
Operation guide
Always pay attention to the following before operation.
・Depending on the ink types, storage temperature or storage
term the clogging formed by residual ink the circula-
tion system may occur even if this process is performed.
・For the storing method, it is recommended contact your
local distributor.
Drain the Ink.
3
Perform procedures
● Conduct until ink drainage.
● Perform operation in accordance with the operation guide on the screen and drain the ink.
6-41 ●Long-term Shutdown
[Stop ]
Eject ink
Cleaning stop
Nozzle 2 backwash
Ink filter
replacement
Process after
long-term shutdown
Proc. status:
[Stop ]
long-term shutdown
Proc. status:
-(a) to 2 -(e) of (2) operation in "6.3 Replacing the ink".
2
2018.07.07 12:45
Com=0
Makeup Ink
No-cleaning stop
HOME
Gutter cleaning
Prev.Dsp. Next Dsp.
Ink circulation
Cancel
Makeup refill
Start/
Continue
2018.07.07 12:45
Com=0
A InkDra.
Systemclean
InkDrainage
Systemclean
InkDrainage
↓
Abort
Start/
Continue
Start/Continue
Start/Continue