Hitachi UX Twin-Nozzle Technical Manual page 120

● [If not using the waste solution bottle]
● Connect the recovery tube to the accessory drain tube and insert it into the beaker.
●
If ink is accidentally spilt, wipe it up promptly with wiping paper or something similar.
In addition, do not close the maintenance cover until you are sure that the wiped
portion has completely dried.
(
b) Press the Start/Continue .
Ink circulating inside the printer is drained from the recovery tube into the waste solution bottle or the
beaker.
● To stop drainage, press the Abort .
(
c) There is no need to drain ink if it is within the replacement period for the ink in the ink
tank. Press Abort and proceed to step
Circulation control
Process：Ink replacement
Operation guide
Replace Ink cartridge.
When ready, press <Start/Continue>.
Follow the on-screen instructions to return the recovery tube to its original position and press
Start/Continue .
You are returned to the "Circulation control" screen.
● If you have aborted the sequence, perform the procedure from step
* If you have aborted the sequence, be sure to return the recovery tube to its original position.
6-7 ●Replacing the ink
Recovery tube
Insert
Drain tube
[Service ]
Proc. status:
Beaker
Clean the drain tube with makeup after
using. Otherwise it may be clogged with
ink and cause the pressure in the
recovery line to rise abnormally the next
time it is used.
CAUTION
2
(e).
2018.07.07 12:45
Com=0
Ink Drainage
R InkDra.
Drawing
Ink rep.
Ink refill
Abort
Start/
Continue
CAUTION
1 again.