Hitachi UX Twin-Nozzle Technical Manual page 122

(
a) Set a new ink cartridge bottle in the ink tank.
Set a new cartridge bottle.
(b) Return top and bottom reversal of the ink filter to its original state in accordance with
the guidance.
● Confirm that the ink filter is set as shown in the figure below. (Piping D is on the right.)
Circulation control
Process：Ink replacement
Operation guide
Make sure that ink filter is properly set.
When ready, press <Start/Continue>.
(
c) Return the inner cover to its original position.
(
d) Place the end of the print head in the beaker.
● Provide against an ink beam bend.
6-9 ●Replacing the ink
If ink is accidentally spilt, wipe it up
promptly with wiping paper or
something similar.
In addition, do not close the
maintenance cover until you are
sure that the wiped portion has
completely dried.
Piping(C)
Piping(D)
Ink filter
[Service ]
Com=0
Drawing
Proc. status:
CAUTION
2018.07.07 12:45
Ink Drainage
R InkDra.
Ink rep.
Ink refill
Abort
Start/
Continue