Hitachi UX Twin-Nozzle Technical Manual page 119

(
a) Put the ink filter tubes down, and disconnect the recovery tube and connect it to the
waste solution bottle.
●
If the waste bottle is not available at hand, a container which holds more than 1.5 liter
of content shall be used. Do not use a container mode of other rhan polypropylene,
polyethylene, fluororesin, glass or stainless. Also avoid using soft container.
● Open the maintenance cover and remove the inner cover.
● Pull down the clamp toward you and turn the ink filter upside down.
● Disconnect the recovery tube from the main ink tank.
Recovery tube
Disconnect
the joint.
● [If using the waste solution bottle]
● Connect the recovery tube to the accessory waste solution bottle.
Recovery tube
Waste solution
bottle
CAUTION
Recovery tube
Ink filter
Recovery tube
Clamp
Main ink tank
Main ink resoirver
Ink filter tube
How to disconnect and connect the
joints of the recovery tube and
waste solution bottle
<Disconnecting>
Lock release
● Clean the waste solution bottle with makeup
after using. Otherwise it may be clogged with
ink and cause the pressure in the recovery
line to rise abnormally the next time it is used.
● Do not leave ink contained in the waste
solution bottle for an extended period of time.
● Do not store the waste solution bottle in
places exposed to high temperatures.
● Be careful that the ink does not spill when
disconnecting the joint of the waste solution
bottle.
Ink filter
<Connecting>
Lock
CAUTION
●Replacing the ink 6-6